DMX Control-Distribution-Software-Hardware
Please allow minimum 10 day Delivery for Enttec Hardware
Save $5.25
The DMX leads will fit standard DMX plugs and sockets on all your lights. The fit is tight and wll not fall out. There is no latch on the female en...
View full details
Save $5.40
The DMX leads will fit standard DMX plugs and sockets on all your lights. The fit is tight and wll not fall out. There is no latch on the female en...
View full details
Save $6.00
The DMX leads will fit standard DMX plugs and sockets on all your lights. The fit is tight and wll not fall out. There is no latch on the female en...
View full details
3 Pin XLR Female to 5 Pin XLR Male Used for DMX 5-3 pin conversion
3 Pin XLR Male to 5 Pin XLR Female Used for DMX 3-5pin Conversion 150mm long
Sold out
DMX Terminator-120ohm Used at the end of your DMX run to keep your lights stable.
20M ILDA cable Allows you to control your laser using software on your PCUSB interface/software required
Save $24.00
FOUR WAY DMX SIGNAL AMPLIFYING DISTRIBUTORone input with four outputsfully compliant to dmx-512 specification3 pin XLR input and a passive loop th...
View full details
Sold out
Two banks of faders labeled 1-12 and 13-24, in a typical two preset configuration for setting up general lighting looks and manual operation. Thre...
View full details